RioRand 2-Pack PP150 100 MHz Oscilloscope Clip Probes with Accessory Kit (2PCS) (B)

I would buy again if the need comes again.

Good accessory to go with acope

I bought these for my Tektronix 2445A scope, this is an analog scope with a range of up to 150mhz so nothing too intense. These probes work perfect for it. I imagine if you're working on something that can work at +500mhz, noise sensitive projects, or other extremely fast and subtle signalling these probably aren't up to that kind of a job. I performed a few tests to make sure they were working properly, and luckily they seemed perfect out of box though I've only tested them up to 50mhz at ~100mv.Pros.1. Probes come in pair with ground clips and hook tips.2. Probes are built well and feel solidCons.1. Adjusting probe compensation seems to not effect anything when atten is switched to 10x2. 10x atten does not pick up at all. One probe its open and always at 0v and the other I lose the beam on no matter the division set for voltage or time. (I dont need this for what I do , but you may).Conclusion:If you need a stand in, these are perfectly fine. If you need something for high frequency, or for the 10x attenuation, dont bother. It works great on my analog scope, So I assume these will work fine for most modern full digital scopes if you're just doing simple hobby stuff.

I was quite happy when these arrived to pull them out of the packaging and find that they feel very well-made for this price point. They have all the normal stuff you'd expect from probes - 360 degree rotation at the BNC, solid probe hooks, assorted colored clips, and nice long strain reliefs on either side of the cable.The cables themselves aren't fancy silicone or anything but seem more than adequate for the task at hand - which is hobbyist use. I'm not a professional and can't speak to anything more than what I know, which is very basic usage.But for my purposes they're quite good. I was pleasantly surprised by the general quality of the cables given how cheap they are and I haven't had any issues with them at all. I don't really expect to either.

These are OK starter probes for your second hand Oscilloscope. They seem to calibrate to clean edges, and do not appear to distort the waveform at the frequencies they are designed for.You'll probably want something better later on, but these will get you going. These would be good to have if you ever take your scope onsite or if you loan it to a friend. They are not too expensive to lose.The ground leads are a little long, and mine didn't come with the spring grounds pictured in the manual. But I really can't complain.I ended up getting two sets to use for SPI protocol analysis, so I can honestly say I would buy again ( I actually did).

Very good product! Thank you.

I have a Rigol DS1054 scope. I was using these with that scope all day yesterday and they seem great. I often had trouble with the original probes because the 1x/10x switch was easy to bump without realizing it. Not trouble with that with these so far. But you can only say so much after only 1 day of road time with anything.

I purchased a used oscilloscope off eBay, and it did not probes. I purchased these probes because of the price and shipping made them seem like quite a deal. When I got the probes I was very impressed that they came in a high quality, very thick plastic pouch. The probes come with what colors so you cannot tell them apart.They seem like they're high quality and very durable. I would bet these probes will last as long as I have my oscilloscope. The probes themselves have a 1X and 10x attenuation adjustment. The screw connectors also some high-quality and fit correctly on my oscilloscope.I would recommend the purchase of these probes.