Monoprice Cat6A Ethernet Patch Cable - Snagless RJ45, 550Mhz, 10G, UTP, Pure Bare Copper Wire, 30AWG, 10-Pack, 3 Feet, Blue - SlimRun Series

These patch cables provide a great value and clean look in a rack. When paired with a plate and keystone jacks, you can really clean up your setup. Bandwidth and PoE worked fine through these and all cables tested well.

Work great. Good quality and the etherlighting from my Ubiquiti switch comes through pretty well. I bought both the 1' and the 6" versions, they were true to length and both are connected and worked perfectly. Compared to Ubiquiti's price for their cables, these are well worth it IMO.

These cables are the best for my rack. They look great and never have a problem with them. I used to make my own cables but this is easier and looks much better. Being so thing they are every easy to maneuver.

Exactly as described, rebuttal brand these are my go to cables to clear the clutter and with prime shilling easier to order here than direct

UPDATE:I discovered the problem regarding why these cables are so hard to disconnect. In thew first picture, the flexible rubber tab is on top of the plastic spring loaded clip that holds the connector in place. This is the correct orientation. The second picture shows the rubber tab underneath the plastic tab and this is incorrect. It limits how far down you can press the plastic tab to disengage the connector. Based on this new info, I've changed my review to 5 stars and highly recommend these patch cables. My apologies to the vendor for the erroneous info that was initially posted.These patch cables are great electrically and have no impact whatsoever on the performance of my home network. However, they are EXTREMELY difficult to disconnect. There is something about how the clip is made to hold it in place that is causing this. These are the only cables I have issues with (I've tried several other cables and they all disengage just fine). Given that they normally don't get disconnected, I decided to keep them. However, if I had to swap out my 48 port switch or keystone patch panel, it would take me20 minutes or so to disconnect all my cables. If it were not for this issue, I'd have given this a five star rating.

As others mentioned, these come in a single loop, not packaged separately. They’re annoying to separate but if you’re careful, not so bad. Extra minute or so of effort

I didn't read the description very well or I would have realized that these are not normal ethernet cables. They are very thin. Had I known that I would have worried that the small diameter would also make them more susceptible to kinking, and probablt wouild have bought another brand. I will need to be a little more careful than I would with a typical Cat6 cable. If they get tangled then pulling on them could cause the cable to kink and consequently break, but the reality is that their thinness made it very easy to route several of these along the edge of my desk using only small command hooks to keep them all in place.Using these cables, my network speeds are better than ever but that could also be due to the fact that I replaced my network switch at the same time.Bottom line: I wouldn't want to use these in an environment where they are being plugged in and unpluged repeatedly (like as a portable cable for a laptop, but if you are going to route them and then mostly leave them connected, then I would certainly recommend them.

Not much to say, perfect patch panel cables! Made in vietnam and are amazing quality. Nice and light weight and all of them have good connections. No rejects.